Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modelling the below permanet magnet in comsol
Posted 2011年10月31日 GMT-4 13:21 Version 4.0a 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
here are the details I have regarding a permanent magnet,
Width 2'' ± 0.005''
Length 2'' ± 0.005''
Thickness 0.25'' ± 0.005''
Material Licensed NdFeB
Grade N45
Plating/Coating Ni-Cu-Ni (Silver in Color)
Magnetized Thickness, Poles On Flat Face, Single Pole, Poles Unmarked
Surface Gauss 2516
Magnet Weight 4.835 oz
Pull Strength 182.3 lbs
I am trying to model a dipole geometry with 2 magnets separated by 63 mm with this and get the 3D field inbetween. What constitutive relatio shoul i use for the magnet ? ( b = mu(H +M)?) How do i pick the direction and magnitude of M? I only know the surface gauss - 2500?? would i need to map out the gauss along the two pole surfaces with a gaussmeter? If so how would I enter that data into comsol?
Thanks in advance,
Indira
here are the details I have regarding a permanent magnet,
Width 2'' ± 0.005''
Length 2'' ± 0.005''
Thickness 0.25'' ± 0.005''
Material Licensed NdFeB
Grade N45
Plating/Coating Ni-Cu-Ni (Silver in Color)
Magnetized Thickness, Poles On Flat Face, Single Pole, Poles Unmarked
Surface Gauss 2516
Magnet Weight 4.835 oz
Pull Strength 182.3 lbs
I am trying to model a dipole geometry with 2 magnets separated by 63 mm with this and get the 3D field inbetween. What constitutive relatio shoul i use for the magnet ? ( b = mu(H +M)?) How do i pick the direction and magnitude of M? I only know the surface gauss - 2500?? would i need to map out the gauss along the two pole surfaces with a gaussmeter? If so how would I enter that data into comsol?
Thanks in advance,
Indira
1 Reply Last Post 2011年11月1日 GMT-4 04:35
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
The lazy way, I believe, since you have the surface gauss value, is to use a undefined magnetisation "MyM" and let COMSOL find the value to give you the equivalent surface magnetisation. For one magnet in free air/vacuum around.
Then to use this magnetisation found, in your full model
--
Good luck
Ivar
The lazy way, I believe, since you have the surface gauss value, is to use a undefined magnetisation "MyM" and let COMSOL find the value to give you the equivalent surface magnetisation. For one magnet in free air/vacuum around.
Then to use this magnetisation found, in your full model
--
Good luck
Ivar