Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
"grooved/finned" surface
Posted 2011年11月17日 GMT-5 00:40 Fluid & Heat, Computational Fluid Dynamics (CFD), Geometry 1 Reply
Please login with a confirmed email address before reporting spam
Hi everyone! I'm trying to make "grooved/finned" inside-surface on one of my pipe-model, but i have little difficulties here. Could someone help me with this geometry-problem?
I have just add two geometries (cylindrical&helix) and before i even start to do mesh i got error message below: "Error_in_parameter_domain_topological_analysis".
-Antti
I have just add two geometries (cylindrical&helix) and before i even start to do mesh i got error message below: "Error_in_parameter_domain_topological_analysis".
-Antti
1 Reply Last Post 2011年11月17日 GMT-5 01:37
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
toroidal, or twisted volumes are delicate to express. be sure you geometry relative feature size is adequate, that your volume do not self interact, and that the meshing will not self-interact. You need fine enough mesh density to resolve correctly the geometrical curvature. I do not know of other things that can go wrong ;)
--
Good luck
Ivar
toroidal, or twisted volumes are delicate to express. be sure you geometry relative feature size is adequate, that your volume do not self interact, and that the meshing will not self-interact. You need fine enough mesh density to resolve correctly the geometrical curvature. I do not know of other things that can go wrong ;)
--
Good luck
Ivar