Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Contact surface defination

Please login with a confirmed email address before reporting spam

Hello everyone,

I am trying to model a sphere pushing into a tapered cylinder. To do so, I have created a 2D model with a load. Since the two surfaces will be tangent to the sphere surface, I use contact pair to handle the point contact issue. The sphere will deform under this load and move forward a little bit. I want to know the distance under different load.
However, the plot of the distance indicates that something is wrong. The disntance of the contat point is zero, which is shown in the attachment
Does anyone know why this happens? I thought maybe this is a common problem that might root in a simple mistake in defining the contact.

Thank you

Pengchuan


3 Replies Last Post 2011年11月27日 GMT-5 23:11
Nagi Elabbasi Facebook Reality Labs

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月22日 GMT-5 14:19
The problem seems to be that the sphere is attached to the plates at the contact points. Make sure you keep the parts separate by using the COMSOL Assembly instead of Union feature.

Nagi Elabbasi
Veryst Engineering
The problem seems to be that the sphere is attached to the plates at the contact points. Make sure you keep the parts separate by using the COMSOL Assembly instead of Union feature. Nagi Elabbasi Veryst Engineering

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月22日 GMT-5 17:04

The problem seems to be that the sphere is attached to the plates at the contact points. Make sure you keep the parts separate by using the COMSOL Assembly instead of Union feature.

Nagi Elabbasi
Veryst Engineering


Can you make it more specifically? I didn't do any union operation on this model.
[QUOTE] The problem seems to be that the sphere is attached to the plates at the contact points. Make sure you keep the parts separate by using the COMSOL Assembly instead of Union feature. Nagi Elabbasi Veryst Engineering [/QUOTE] Can you make it more specifically? I didn't do any union operation on this model.

Nagi Elabbasi Facebook Reality Labs

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月27日 GMT-5 23:11
Check the last node under Geometry. Change “Finalization method” to “Form an assembly” instead of the default “Form a union”.
Check the last node under Geometry. Change “Finalization method” to “Form an assembly” instead of the default “Form a union”.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.