Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stress Plot Formation

Posted 2011年11月26日 GMT-5 18:57 Results & Visualization Version 3.5a, Version 4.0, Version 4.0a, Version 4.1, Version 4.2, Version 4.2a 4 Replies

Theodore Baltis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

When I go to plot stresses, does Comsol use nodal averaging or are these stresses element-based? Can I choose which to use?

Thank you in advance,
Theodore
4 Replies Last Post 2011年11月28日 GMT-5 11:13
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月27日 GMT-5 14:54
Hi

check the doc, you have many sress elements for different cases

--
Good luck
Ivar
Hi check the doc, you have many sress elements for different cases -- Good luck Ivar
Theodore Baltis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月27日 GMT-5 15:58
Hi Ivar,

I've been reading through the documentation for a while and cannot find anything. Can you explain what you mean by "many stress elements for different cases"?

Thank you,
Theodore
Hi Ivar, I've been reading through the documentation for a while and cannot find anything. Can you explain what you mean by "many stress elements for different cases"? Thank you, Theodore
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月27日 GMT-5 23:07
The default stress plot is nodal averaged or “Smoothed”. You can change that to element based by setting Smoothing=None in the Quality tab of the result plot. COMSOL also has a more accurate stress recovery algorithm, based on the superconvergent patch recovery technique, which you can activate by selecting Recover=”Within domains”, also in the Quality tab.

Nagi Elabbasi
Veryst Engineering
The default stress plot is nodal averaged or “Smoothed”. You can change that to element based by setting Smoothing=None in the Quality tab of the result plot. COMSOL also has a more accurate stress recovery algorithm, based on the superconvergent patch recovery technique, which you can activate by selecting Recover=”Within domains”, also in the Quality tab. Nagi Elabbasi Veryst Engineering
Theodore Baltis
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年11月28日 GMT-5 11:13
Thank you Nagi. That helped tremendously. I knew it was in there somewhere.

-Theodore
Thank you Nagi. That helped tremendously. I knew it was in there somewhere. -Theodore

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content