Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to get perfect bonding between two materials?
Posted 2011年12月11日 GMT-5 14:31 2 Replies
Please login with a confirmed email address before reporting spam
Hi,
I want to bond a PZT to an Aluminum plate, and I was wondering, how can I do it, Is it by using a perfectly matched layer?
I want to bond a PZT to an Aluminum plate, and I was wondering, how can I do it, Is it by using a perfectly matched layer?
2 Replies Last Post 2011年12月12日 GMT-5 04:27
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
"bounding of stress and strain properties is obtained by default in geometry "union" mode which implies "continuity of flux on the interface boundary. In fact "union" means that COMSOL merges the "up" and "down" side of any common boundary to one single element, with continuity across it, take a look at the equations, and read the doc
--
Good luck
Ivar
"bounding of stress and strain properties is obtained by default in geometry "union" mode which implies "continuity of flux on the interface boundary. In fact "union" means that COMSOL merges the "up" and "down" side of any common boundary to one single element, with continuity across it, take a look at the equations, and read the doc
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you very much, it really helped