Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to partion 3D results without partioning the geometry

Posted 2020年3月15日 GMT-4 13:27 Fluid & Heat, Geometry, Results & Visualization Version 5.4 1 Reply

Rogelio Garcia Fernandez Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everyone! First of all, thank you so much for the time you spend reading my question.

I have results (velocities) from a 3D model. The results are realistic and accurate; however, I want to see the visual results from the 3D surface plot in the interior of my 3D object. My 3d geometry is symmetric, but I do not want to partition the object physically. I only want to partition the results so that I can be able to see how the velocities behave in the interior of my object. How could I do this task?

1 Reply Last Post 2020年3月15日 GMT-4 15:00
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2020年3月15日 GMT-4 15:00

Results > Data Sets > More 3D Data Sets > Parameterized Surface.

Results > Data Sets > More 3D Data Sets > Parameterized Surface.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content