Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Plot y+ in Low Reynolds k-Epsilon Model
Posted 2012年2月27日 GMT-5 06:10 Fluid & Heat, Computational Fluid Dynamics (CFD), Results & Visualization Version 4.2, Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi folks!
Does anyone know how to plot the y+ (wall lift off in viscous units) in a Low Reynolds
k-Epsilon Model interface?
I am having difficulties accomplishing it...
Best Regards,
Rui Silva
Does anyone know how to plot the y+ (wall lift off in viscous units) in a Low Reynolds
k-Epsilon Model interface?
I am having difficulties accomplishing it...
Best Regards,
Rui Silva
1 Reply Last Post 2012年3月23日 GMT-4 04:03
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I don't know about the Low Reynolds number model, but if wall functions are used, then you do as follows:
1. Select a 2-D plot group, with the data-set from your RANS solver.
2. In that group, make a line-plot. I tried doing a 2-d plot but then there is no way to acces the y+ values.
Maybe there are some other way, but I hope this helps.
I don't know about the Low Reynolds number model, but if wall functions are used, then you do as follows:
1. Select a 2-D plot group, with the data-set from your RANS solver.
2. In that group, make a line-plot. I tried doing a 2-d plot but then there is no way to acces the y+ values.
Maybe there are some other way, but I hope this helps.