Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Units in parameter cases

Please login with a confirmed email address before reporting spam

Dear colleagues, In order to use a parametric sweep I am defining cases to my default parameter list. Now, when defining units in these cases I get an error message. Apparently I must define the cases as purely numerical value. My question is: Is the unit inherited from the parameter list or not? Let's assume I define a length L1 as 5 [mm] in the parameter list and as 10 in case 1. Is the value now in [mm] as in the parameter list or in [cm] which is the globally define unit for length? Thanks for your help.

Best,


0 Replies Last Post 2020年10月5日 GMT-4 08:39
COMSOL Moderator

Hello Tar Cisi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.