Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Atmospheric Corrosion using Shell Current Distribution - Insulation Boundary
Posted 2021年4月1日 GMT-4 11:20 Corrosion & Corrosion Protection, Electrochemistry 0 Replies
Please login with a confirmed email address before reporting spam
Is there a way to prevent current distribution through a shell electrolyte? For example, in the busbar example model the aluminum and copper terminal boundaries are connected to ground and current sources, respectively. In a working system these surfaces would not be exposed to atmosphere, therefore, they would not be covered by an electrolyte. Is there are way to designate these electrolyte boundaries as non-conductive? On other words, removing them from the current distribution solver? I have tried setting the conductivity to zero, but I get an error. Setting the conductivity to exceedly low values just causes large potential drops.
Hello Jason Lee
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.