Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Boundary area, domain volume and average flux through a boundary
Posted 2012年5月28日 GMT-4 16:06 Heat Transfer & Phase Change, Geometry, Parameters, Variables, & Functions Version 4.2, Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
1) How to calculate a area of a boundary or volume of a domain in 3D Multiphysics model ?
2) How to calculate an average value for a flux (for example heat power) which through a boundary in 3D
Multiphysics model ?
2) How to calculate an average value for a flux (for example heat power) which through a boundary in 3D
Multiphysics model ?
1 Reply Last Post 2012年5月29日 GMT-4 02:04
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
the length, area respective volume of a 1D, 2D respective 3D Entioty can be obtained by the integration of the operand "1"
And the average is now directly calculated by the "average" operatur your Define on an enetity (domain Boundary ...)
To get the coordinate of a point, you set an integration operant on that point (only 1 point) then integrate intop1(x), intop(y) ... It's a bit heavy, but perfectly logic, and itegration being a sum over elements or "continuous" sections of an entity
--
Good luck
Ivar
the length, area respective volume of a 1D, 2D respective 3D Entioty can be obtained by the integration of the operand "1"
And the average is now directly calculated by the "average" operatur your Define on an enetity (domain Boundary ...)
To get the coordinate of a point, you set an integration operant on that point (only 1 point) then integrate intop1(x), intop(y) ... It's a bit heavy, but perfectly logic, and itegration being a sum over elements or "continuous" sections of an entity
--
Good luck
Ivar