Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to apply a load to bend a slender cylinder into a semicircle

Posted 2021年8月1日 GMT-4 02:28 Structural & Acoustics 1 Reply

祥和 刘
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi everyone: I want to apply a load to bend a slender cylinder into a semicircle.Suppose there is a slender straight cylinder with one end fixed and a load applied at the other end. How to apply this load can make the cylinder gradually bend to a semicircle? alt text

1 Reply Last Post 2021年8月2日 GMT-4 14:30
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年8月2日 GMT-4 14:30

Hello,

This tutorial illustrates how to perform the large deformation analysis of a beam.

Best regards,

Jeff

-------------------
Jeff Hiller
Hello, [This tutorial](https://www.comsol.com/model/large-deformation-analysis-of-a-beam-204) illustrates how to perform the large deformation analysis of a beam. Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content