Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Failed to copy mesh: Periodic Nanoparticle on Substrate structure

Please login with a confirmed email address before reporting spam

Hello All,

I am trying to construct a periodic plasmonic array on a substrate. The image of the structure is attached. There are silver trinagular particles placed on top of the Quartz substrate. These plasmonic nanoparticles are placed within thin silica spacer layer. I am trying to do meshing by following the "scatterer on a substrate" model. However I am getting error when building the meshing. The error is generated by the copy face 1 (error image attached). This error doesn't occur if I remove the spacer layer. The nanoparticle height is 45 nm and spacer layer varies from 45 nm to 100 nm (spacer height is variable). Any suggestions? Best Regards,

Hamza



1 Reply Last Post 2021年8月11日 GMT-4 18:23

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年8月11日 GMT-4 18:23

You can upload your model here then I will have a look.

You can upload your model here then I will have a look.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.