Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Line plot in busbar example

Posted 2012年7月3日 GMT-4 10:10 Low-Frequency Electromagnetics 2 Replies

Martin Hediger
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear Comsol users
In the busbar example, I would like to plot the electrostatic potential along a line connecting the midpoints of the two bolts on the base part of the busbar (I want to see the potential across the material boundary).
So the line should be of the same length as the width of the busbar and lie on the mid points of both titanium bolts on the busbar surface.
How do I do that?

Thanks for hints.
2 Replies Last Post 2012年7月4日 GMT-4 07:46
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年7月4日 GMT-4 01:38
Hi

check the features in the Results - Data - Set cut line, plane ...

--
Good luck
Ivar
Hi check the features in the Results - Data - Set cut line, plane ... -- Good luck Ivar
Martin Hediger
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年7月4日 GMT-4 07:46
Thanks. Couldn't find the cutline anymore.
Thanks. Couldn't find the cutline anymore.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content