Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Level Set Method: Unable to Re-compute

Posted 2012年8月21日 GMT-4 09:32 Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Chemical Reaction Engineering, Geometry, Materials, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers Version 4.0, Version 4.0a, Version 4.1, Version 4.2, Version 4.2a, Version 4.3 1 Reply

Lindsey Jantz
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I'm using two-phase flow, level set to simulate mixing of two fluids (gases) and got my model to run (is not correct in current state but did run), however, when I make a small change, I cannot get it to compute. I tried clearing all meshes, all solutions and resetting, but it still doesn't work.
Any thoughts?

Attachments:

1 Reply Last Post 2012年8月22日 GMT-4 05:11
Tero Hietanen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年8月22日 GMT-4 05:11
Hi Lindsey

Did you solved this problem already? Try to delete all solvers and make new ones with "show default solver".

Best regards

Tero
Hi Lindsey Did you solved this problem already? Try to delete all solvers and make new ones with "show default solver". Best regards Tero

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content