Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Couple temperatures along an edge

Posted 2012年9月4日 GMT-4 05:12 Heat Transfer & Phase Change Version 4.2a 0 Replies

Abhishek Basak
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to figure out how to couple the temperature DOF in a thermal (conduction) analysis for all nodes lying along an edge of a model. I.e. all such nodes would have the same temperature value, but the value itself is unknown. Any ideas?

Regards,
Abhishek
0 Replies Last Post 2012年9月4日 GMT-4 05:12
COMSOL Moderator

Hello Abhishek Basak

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content