Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Selection based on boundary area

José Dinarte Vieira Goulart

Please login with a confirmed email address before reporting spam

There is any way to perform geometry boundary selections based on their surface area?

I ask because i have many designs and they have to run on same mesh, so every time i update The geometry i lost my selections.


0 Replies Last Post 2022年9月20日 GMT-4 10:09
COMSOL Moderator

Hello José Dinarte Vieira Goulart

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.