Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Sensitivity Plotting

Posted 2012年9月15日 GMT-4 16:28 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.2 1 Reply

Doyle Baker
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

When modeling a pressure sensor how can I create a plot that shows the subsequent sensitivity of the device in terms of: Voltage (V) /unit pressure (kPa).
1 Reply Last Post 2012年9月16日 GMT-4 02:42
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年9月16日 GMT-4 02:42
Hi

I would propose that you run a continuation sweep solver case with increasing pressure and then use the derived Variable postprocessing nodes to define the average voltage per pressure value, you get a table output that you might get also as a graph, with a click on the graph icone

--
Good luck
Ivar
Hi I would propose that you run a continuation sweep solver case with increasing pressure and then use the derived Variable postprocessing nodes to define the average voltage per pressure value, you get a table output that you might get also as a graph, with a click on the graph icone -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content