Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Change contact pair to identity pair keeping resulting position

Please login with a confirmed email address before reporting spam

Hi,

I have a scenario I don't manage to solve. For example:

Step 1: A cylinder is sliding inside a upper block and applies a load to the lower bloc. It has a resulting displacement and the lower bloc is in a stress state.

Step 2: the cylinder is clamped at the resulting position to the upper block and the stress state of the lower block induce a load to the upper block thru the cylinder.

I tried to:

  • use two stationnary steps
  • in the second step change the contact pair to identity pair and remove the initial load

    but it does not work. It behaves as if the identity pair was applied to the initial position, no load is applied to the upper block.

    Any idea ? I joined files to detail the problem.

    Thanks!...



0 Replies Last Post 2023年2月16日 GMT-5 03:22
COMSOL Moderator

Hello Guillaume LE TETU

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.