Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Modelling Dipole Antenna

Posted 2023年11月2日 GMT-4 07:55 2 Replies

Charumathi P R
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I tried to model dipole antenna (by following comsol guidelines). While following the steps, Impedance Boundary conditions, I can't select boundary from the geometry. The geometry selected looks like this. Please do tell me where I went wrong. .

2 Replies Last Post 2023年11月2日 GMT-4 09:20
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 2023年11月2日 GMT-4 08:40
Updated: 1 year ago 2023年11月2日 GMT-4 08:40

Could it be that you have hidden the boundary you are trying to select? It looks that way on the screenshot you attached.

Jeff

-------------------
Jeff Hiller
Could it be that you have hidden the boundary you are trying to select? It looks that way on the screenshot you attached. Jeff
Magnus Ringh COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 2023年11月2日 GMT-4 09:20

Hi,

I think that Jeff is right. Another tip is to use the mouse wheel to move between all boundaries or domains in a 3D geometry that the mouse is pointing toward. It can make it easier to select hidden parts of the geometry.

Best,

Magnus

Hi, I think that Jeff is right. Another tip is to use the mouse wheel to move between all boundaries or domains in a 3D geometry that the mouse is pointing toward. It can make it easier to select hidden parts of the geometry. Best, Magnus

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content