Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

geometry

Posted 2012年11月27日 GMT-5 04:23 Geometry Version 4.0a 1 Reply

Eba Flora
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How to extrude a semi-ellipse without an partition in the centre. Anybody help me.


1 Reply Last Post 2012年11月27日 GMT-5 05:24
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年11月27日 GMT-5 05:24
Hi
In COMSOL your Bezier curves can be set as lines or surfaces (then they are closed surfaces) Is that what you are looking for ?
Select open or closed curve

--
Good luck
Ivar
Hi In COMSOL your Bezier curves can be set as lines or surfaces (then they are closed surfaces) Is that what you are looking for ? Select open or closed curve -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content