Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
High current output
Posted 2013年1月18日 GMT-5 03:12 Electromagnetic Heating, Low-Frequency Electromagnetics, Heat Transfer & Phase Change 3 Replies
Please login with a confirmed email address before reporting spam
Hi everyone,
I am simulating a heat treatment with the induction heating module and I'm facing a problem concerning the single turn coil.
More specific I import as a coil excitation the a power of 640kW and I get a voltage of 120V and 10700A.
The voltage is fine, but the current is the double of what I expected. Any ideas of how can I fix this or check what's wrong?
Thank you!
Rosa
I am simulating a heat treatment with the induction heating module and I'm facing a problem concerning the single turn coil.
More specific I import as a coil excitation the a power of 640kW and I get a voltage of 120V and 10700A.
The voltage is fine, but the current is the double of what I expected. Any ideas of how can I fix this or check what's wrong?
Thank you!
Rosa
3 Replies Last Post 2013年1月18日 GMT-5 08:22
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
could it be an issue with a mix of Amplitudes and RMS values ?
--
Good luck
Ivar
could it be an issue with a mix of Amplitudes and RMS values ?
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I haven't specified any value as a rms so there is no mix. Right?
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
not necessarily, normally we specify amplitudes, but depending on the physics (and the version) at some stage COMSOL proposed back RMS values for frequency sweep analysis, need to look up the appropriate doc (corresponding to your current version, or dig into the COMSOL equations (preferences view equations on)
--
Good luck
Ivar
not necessarily, normally we specify amplitudes, but depending on the physics (and the version) at some stage COMSOL proposed back RMS values for frequency sweep analysis, need to look up the appropriate doc (corresponding to your current version, or dig into the COMSOL equations (preferences view equations on)
--
Good luck
Ivar