Microwave heating interface - How to simulate power that changes over time

Please login with a confirmed email address before reporting spam

Hello. I'm simulating microwave heating equipment with microwave heating and heat transfer in solids interface.

My microwave heating equipment has PID controller so it controls its port power to reach target temperature.Input power of the microwave heating equipment varies from 0% to 100% over time.

How can I change the input power of port that changes over time in Microwave heating module?

I appreciate any advice.


2 Replies Last Post 2024年10月8日 GMT-4 08:57

Please login with a confirmed email address before reporting spam

Posted: 2 months ago 2024年10月7日 GMT-4 12:24

In a frequency-transient study the RF power can be an explicit function of time.

You can easily implement a proportional or proportional-derivative controller by defining an integration or average coupling variable. A PID controller is also possible but may require ODE physics.

In a frequency-transient study the RF power can be an explicit function of time. You can easily implement a proportional or proportional-derivative controller by defining an integration or average coupling variable. A PID controller is also possible but may require ODE physics.

Walter Frei COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 months ago 2024年10月8日 GMT-4 08:57

You may also find this useful: https://www.comsol.com/support/learning-center/article/46881#anchor-5

You may also find this useful: https://www.comsol.com/support/learning-center/article/46881#anchor-5

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.