Regarding non-physical reflections in comsol reflectance spectra, in waveoptics module.

Anand Eswara Rao Aryasomayajula

Please login with a confirmed email address before reporting spam

Hello everyone, I am simulating reflectance spectra (lambda range 400 nm to 1100 nm) of a periodic structure of dielectric spheres (triangular lattice of a monolayer) on a silicon substrate in "The COMSOL multiphysics wave optics module." The periodicity of the unit cell is around 400nm. I included diffraction orders and implemented PML. Instead of using silicon as a domain, I used impedance boundary conditions at the bottom with silicon material assigned to the boundary(exit). I am getting unphysical reflections at oblique incidence (not in normal incidence). But if I replace the sphere with the flat dielectric layer, those artifacts will not arise even at oblique incidence. It happened when I placed a sphere in the periodic structure. Moreover, the sharp dips are red-shifting if the angle changes from 45 to 75 deg. Here, the impedance boundary is not the problem; when I simulated with a flat, thin film, I used the impedance boundary instead of the silicon domain. The results of the thin film matched the experimental data (I verified by implementing the silicon boundary; the results are the same in the case of thin film). The problem appears only for the sphere. Is there any way to solve this problem? Thank you.



0 Replies Last Post 2024年10月9日 GMT-4 05:05
COMSOL Moderator

Hello Anand Eswara Rao Aryasomayajula

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.