Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
anode and cathode
Posted 2013年2月26日 GMT-5 10:18 Low-Frequency Electromagnetics, Plasma Physics Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
I'm creating a plasma with a Inductively coupled plasma and laminar flow interface.
I want to put the electrodes (anode and cathode) in the model (within the device) and apply voltage to the electrodes, which would measure the resulting current.
to need it Ballast resistor or another same. in AC/DC module (electrostatics or another interface) there is no Ballast resistor options.
please tell me, how can I do it?
in DC Discharge there is such a possibility but it's interface is used to create the plasma and not possibility use the Inductively coupled plasma interface and DC Discharge interface in one model at the same time.
Thanks for helping
Attachments:
Hello Shahram Roshanpour
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
i added a circuit and an electric potential into the microwave plasma.
it took me a lot of time, since I am not sure I used the right coupling between the circuit and the plasma.
so I am asking you how you managed it?
lukas