Discussion Forum

Forum Home

New Discussion

Note: This discussion is about an older version of the COMSOL Multiphysics^® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Is Cap Face feature is existed in COMSOL 4.00

Posted 2013年3月28日 GMT-4 01:34 Geometry Version 4.0a 3 Replies

rumayan

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am wondering if someone still uses COMSOL 4.00 and can guid me how to block some holes in my geometry. Is Cap face is existed in COMSOL 4.00 as its in COMSOL 4.3

Many thanks
Faisal

3 Replies Last Post 2013年3月28日 GMT-4 22:21

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Hi

I do not beleive it was already in v4.0, anyhow I can only recommend to use a later version (I never trust a .00 revision of any software ;)

--
Good luck
Ivar

Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

Hello Faisal,
"Cap Faces" was added at version 4.2; see www.comsol.com/support/releasenotes/4.2/cad/ .
Best,
Jeff

rumayan

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago

I agree with you.

Thanks
Faisal

Note that while COMSOL employees may participate in the discussion forum, COMSOL^® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Discussion Forum

Is Cap Face feature is existed in COMSOL 4.00

Suggested Content