Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to plot graph b/w preeure vs displacement

Please login with a confirmed email address before reporting spam

i need procedure how to plot grap for pressure sensor and how to observe pressure and displacement value......


1 Reply Last Post 2013年4月3日 GMT-4 10:57
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年4月3日 GMT-4 10:57
Hi

eithjer define a point or an boundary, and get the average value (average operator or integration operator over a point, or over a Data Set "point") and then use the Results Derived values to get a table with pressure (as you probably changed it qwith a parametric sweep) and the average displacement. (or with the max displacement operator)

This is also described in some of the videos on the main site

--
Good luck
Ivar
Hi eithjer define a point or an boundary, and get the average value (average operator or integration operator over a point, or over a Data Set "point") and then use the Results Derived values to get a table with pressure (as you probably changed it qwith a parametric sweep) and the average displacement. (or with the max displacement operator) This is also described in some of the videos on the main site -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.