Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error in elPlastic element.

Posted 2013年6月26日 GMT-4 18:12 Structural Mechanics Version 4.4 2 Replies

Kimia Mortezaei
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello
I ran a geomechanical model and I got this Error "Error in elPlastic element. - Detail: Lambda non positive for plastic point" , Could anyone tell me why this error happens. I used soil plasticity model.
2 Replies Last Post 2014年10月23日 GMT-4 09:35
COMSOL Moderator

Hello Kimia Mortezaei

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Lado Filipovic
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年10月21日 GMT-4 09:44
Hi Kimia,
have you managed to solve this problem? I seem to be getting this as well when using the Linear Elastic Material model where one material has plasticity. When the generated stress reaches the initial yield stress, I get this error.

Any help would be appreciated.
Hi Kimia, have you managed to solve this problem? I seem to be getting this as well when using the Linear Elastic Material model where one material has plasticity. When the generated stress reaches the initial yield stress, I get this error. Any help would be appreciated.
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年10月23日 GMT-4 09:35
This “Lambda” is used to calculate the amount of plastic strain such that the stress remains on the yield surface. I have seen this error when the time step size (or load increment in stationary analysis) is too big, or when convergence tolerances are too loose.

Nagi Elabbasi
Veryst Engineering
This “Lambda” is used to calculate the amount of plastic strain such that the stress remains on the yield surface. I have seen this error when the time step size (or load increment in stationary analysis) is too big, or when convergence tolerances are too loose. Nagi Elabbasi Veryst Engineering

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content