Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Forced convection - horizontal flow against a plane sheet with a blunt edge
Posted 2013年7月27日 GMT-4 07:56 Fluid & Heat, Heat Transfer & Phase Change, Modeling Tools & Definitions, Parameters, Variables, & Functions 1 Reply
Please login with a confirmed email address before reporting spam
Hi folks,
that's my first time I'm working with COMSOL MULTIPHYSICS and I'm trying to simulate a horizontal flow against a plane sheet with a blunt edge.
I use convective and conductive (cc) and Incompressible Navier Stokes (ns) mode with the following properties:
- forced - flow: 35m/s and -30°C
- plane - sheet: +4°C
When I try to solve the problem I always get the following error massage:
Failed to find a solution:
No convergence, even when using the minimum damping factor.
Returned solution has not converged.
Can someone give me a hint how to solve such a problem??? Maybe I just use the wrong models.....
Thx
that's my first time I'm working with COMSOL MULTIPHYSICS and I'm trying to simulate a horizontal flow against a plane sheet with a blunt edge.
I use convective and conductive (cc) and Incompressible Navier Stokes (ns) mode with the following properties:
- forced - flow: 35m/s and -30°C
- plane - sheet: +4°C
When I try to solve the problem I always get the following error massage:
Failed to find a solution:
No convergence, even when using the minimum damping factor.
Returned solution has not converged.
Can someone give me a hint how to solve such a problem??? Maybe I just use the wrong models.....
Thx
1 Reply Last Post 2013年7月29日 GMT-4 18:10
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi,
I fixed it. The mesh wasn't fine enough.
Now I'm trying to make a transient analyse, e.g. change of the plate temperature or the ambient temperature. But I'm a little bit confused about how to set the right solver parameters (of course I set initial values).
Maybe someone have a couple of good tutorials, it seems there are not a lot of "step by step" examples in the web, and as I mentioned above, that's my first time I use COMSOL.
Thx
I fixed it. The mesh wasn't fine enough.
Now I'm trying to make a transient analyse, e.g. change of the plate temperature or the ambient temperature. But I'm a little bit confused about how to set the right solver parameters (of course I set initial values).
Maybe someone have a couple of good tutorials, it seems there are not a lot of "step by step" examples in the web, and as I mentioned above, that's my first time I use COMSOL.
Thx