Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Lorentz force calculation

Posted 2013年9月24日 GMT-4 11:33 Low-Frequency Electromagnetics, Parameters, Variables, & Functions Version 4.3a 1 Reply

Diana David
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to obtain the Lorentz force generated by a coil to a workpiece. I am integrating the Lorentz force over the entire domain (i.e. workpiece), but I was just wondering if COMSOL uses the average force experienced by the workpiece to do that calculation. If I understood it right, force is concentrated on the surface, specifically on the area directly above the coil (assuming workpiece is above the coil and is wider than the coil)?
1 Reply Last Post 2014年11月30日 GMT-5 12:34
COMSOL Moderator

Hello Diana David

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Mohamed Zanaty
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 10 years ago 2014年11月30日 GMT-5 12:34
Hi,

Did you find a solution ? As I have the same problem as yours

Thanks a lot

BR
Mohamed
Hi, Did you find a solution ? As I have the same problem as yours Thanks a lot BR Mohamed

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content