Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to specify Navier slip boundary condition

Please login with a confirmed email address before reporting spam

Hi, all

I am trying to simulate the pressure-driven flow in a straight slip-microchannel using COMSOL 3.5. I am not sure that my specified slip boundary condition is right, but the result is incorrect compared to the analytical solution. I specified the wall slip boundary condition as the sliding wall: Uw=-b*uy, where b is the slip length and uy is the velocity gradient at wall.

Is there anybody who has comments and suggestions on this issue?

Thank you.

Adrian

1 Reply Last Post 2017年1月17日 GMT-5 04:35
COMSOL Moderator

Hello Adrian Chang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Mainendra Kumar Dewangan

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年1月17日 GMT-5 04:35
Hi,
If you know, how to set slip boundary condition please tell me. I am also facing same problem.
Hi, If you know, how to set slip boundary condition please tell me. I am also facing same problem.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.