Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error during Time-Dependent Study with a Moving Mesh

Please login with a confirmed email address before reporting spam

Hi,

I try to run a simulation with a PDE and a Moving Mesh. The calculation always stops with the same error (picture is attached) "Mesh quality could not be achieved".

What can I do to get rid of this error? I have attached the project-file too.

Kind regards,
Arno Tuna


0 Replies Last Post 2013年10月14日 GMT-4 04:16
COMSOL Moderator

Hello Arno Tuna

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.