Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D draw using Comsol

Posted 2013年10月24日 GMT-4 17:20 Geometry Version 4.3 0 Replies

Bozhi Ji
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have a question about the drawing of my chip design. As shown in the image, I want to connect two blocks in the middle to form another domain, I have tried the polygon but it does not form a domain, just some boundaries. could somebody help me to solve this problem.

Thank you very much.

Attachments:

0 Replies Last Post 2013年10月24日 GMT-4 17:20
COMSOL Moderator

Hello Bozhi Ji

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content