Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coupling：How to couple Laminar two-phase flow with electroosmotic

Posted 2014年3月20日 GMT-4 09:36 Fluid & Heat, Microfluidics, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.3b, Version 4.4 0 Replies

Jie Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,everyone.

I‘m trying to simulate a microfluidic chip using electroosmotic pump.Because I want to capture the result that water erupt off the chip into the air,so i introduce the physics— Laminar two-phase flow.

However,when I was coupling the EC mode(in order to emerge electroosmotic in the flow) with the Laminar two-phase flow mode,it came into errors such as "singularity","Maximum numberof Newton iterations "……

So,I beg you all to help me if any of you konw how to do this coupling or konw what's correct mode to use for the Laminar two-phase flow with electoosmotic pump.

Thanks adcanced.
0 Replies Last Post 2014年3月20日 GMT-4 09:36
COMSOL Moderator

Hello Jie Xu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content