Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
how to select a boundary inside a 3D model
Posted 2014年8月26日 GMT-4 13:05 Version 4.3b 1 Reply
Please login with a confirmed email address before reporting spam
Hi All
I am doing a simulation regarding a carbon fibre/epoxy panel in 3D. I would like to add a material radiative flux and heat losses on the surface of the panel. Also, I created a block to represent the air on the panel.
I use Joule Heating and then add Surface-to-Ambient Radiation. I cannot select the inner surface in the model.
I don't know how can I add the losses on the surface.
Please have a look of the attached file. I am using COMSOL 4.3b.
Thank you very much
I am doing a simulation regarding a carbon fibre/epoxy panel in 3D. I would like to add a material radiative flux and heat losses on the surface of the panel. Also, I created a block to represent the air on the panel.
I use Joule Heating and then add Surface-to-Ambient Radiation. I cannot select the inner surface in the model.
I don't know how can I add the losses on the surface.
Please have a look of the attached file. I am using COMSOL 4.3b.
Thank you very much
Attachments:
1 Reply Last Post 2014年8月27日 GMT-4 00:59
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi Ralph,
Please see the attached model. Is that what you asked for?
--
Dima Apter
www.a2z-consulting.com
Please see the attached model. Is that what you asked for?
--
Dima Apter
www.a2z-consulting.com
Attachments: