Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems with static mixer simulation (diffusion vs convective mixing)

Posted 2014年12月9日 GMT-5 15:43 Fluid & Heat, Studies & Solvers 0 Replies

Jon O
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate a static mixer to assess its mixing quality through multiple iterations. It is meant for liquids with minimal diffusion such as latex paint in the realm of 750 Pa*s viscosity. I am having difficulty reducing the diffusion within the liquid as i would like convection to be the main mixing mechanism. I have tested higher velocity, higher viscosity, and lower diffusion coefficient and none of them seem to affect the results of the chds simulation. I would like some guidance as to how to remedy this problem or where i am going wrong. Attached is the Comsol simulation file since it may be helpful if a mistake has been made in the setup. Any help would be greatly appreciated.

Thanks greatly for your time and help,
Jon O

Attachments:

0 Replies Last Post 2014年12月9日 GMT-5 15:43
COMSOL Moderator

Hello Jon O

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content