Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
inverted mesh element near coordinate
Posted 2015年1月15日 GMT-5 15:56 Low-Frequency Electromagnetics, Geometry, Mesh, Studies & Solvers, Structural Mechanics Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
I want to see the mechanical changes due to flow of current through two parallel wires in COMSOL. To do this, first I used two "magnetic field" and "solid mechanic" modules. After getting the results I noticed there is no filed change resulted by mechanical changes which happens due to magnetic forces. After reading previous discussion, I used "moving mesh" module to execute the changes. But then I faced this error:
"inverted mesh element near coordinate"
What I have to do in order to solve the error?
I used this terms in my modeling:
1)free deformed(for all domain, 2-wire and air)
2)prescribe mesh displacement(just for boundary of wire )
With best thanks and regards
Hello Reza Kadkhodaee
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have exactly the same problem although I used the prescribed deformation in all domain instead of free deformation but I think that it's the same thing. However, have you solved your problem??
Thanks a lot
Simona