Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
"Partial slip" flow for "polymer melt" flow inside a "Micro channel"
Posted 2015年2月20日 GMT-5 15:23 0 Replies
Please login with a confirmed email address before reporting spam
I am working on a project where in I need to simulate flow of viscous polymer inside a micro channel.There are two things that differ from the ordinary case ( water through Silicon micro channel ) for me :-
1. There is slip , but it is not full slip but "partial slip" .
( The reason is polymer melt will have "finger" like structures flowing at the edges in front of the meniscus.For a clear idea please refer the figure attached. If no idea is available about a partial slip, input regarding full slip would be welcome as well. Is this thing even possible in COMSOL ?)
2. The other is that it is not water but a thick/ viscous polymer melt.
This is what am I looking for :-
1. I will be grateful if anyone can provide rough steps to go about the simulation and help with the above boundary conditions.
2. Further, possible hick ups I may have / problems I may face for this unique problem.
3. Any other precaution / word of advice is also welcome.
Thanks! I would really appreciate if anyone can help me with all / any of the above steps.
Attachments:
Hello Suhas E P
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.