Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D model boundary (not applicable)

Posted 2015年7月29日 GMT-4 15:52 Computational Fluid Dynamics (CFD), Geometry Version 4.4 1 Reply

Chintan Desai
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have joined two 3D pipes resulting in a T shaped joint. Now i am not able select boundary for assigning temperature and velocity.

Please find the attached screenshot.

Attachments:

1 Reply Last Post 2015年8月3日 GMT-4 08:29
Mao COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年8月3日 GMT-4 08:29
Hi Chintan,

Please go to "Heat Transfer in Fluids" and make sure the pipe domain is selected for that physics.

Best regards,
Mao
Hi Chintan, Please go to "Heat Transfer in Fluids" and make sure the pipe domain is selected for that physics. Best regards, Mao

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content