Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Dyanmic Contact Angle Variation in Multiphase flow

Posted 2015年8月11日 GMT-4 03:55 0 Replies

Siddhartha Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate a multiphase flow in a capillary tube. I have taken a capillary tube of 200mm length and 3mm diameter. I am solving the problem as 2D using level set(tpf). In my problem initially there is a water plug of length 30mm followed by a toluene plug of 15mm length and again there is water for the rest of the tube. So, toluene is in between water. So, two interfaces are formed. At the inlet, the velocity is fully developed flow(parabolic) and the outlet is at 0 Pa pressure.

Now, at the two interfaces the contact angle will vary dynamically and for this I have already derived the relations. But, where to put these two variations is my issue. Can anybody help ?
0 Replies Last Post 2015年8月11日 GMT-4 03:55
COMSOL Moderator

Hello Siddhartha Kumar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content