Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Induced current in single core power cable screen due to alternating magnetic field
Posted 2015年11月2日 GMT-5 16:04 Low-Frequency Electromagnetics 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to model a single core power cable to determine the current induced in the screen of the cable in Comsol 5.1. In the model (which is attached here) I am using the Magnetic field interface and the frequency domain study.
The simulation runs fine but the value I obtain for the induced current in the screen of the cable seems to high. I apply a current of 900A using a single turn coil and calculate the induced current in the screen by performing a surface integral of the induced current density in the screen but the value seems to be too high (of the order of 100A).
Would someone please assist to explain how I can obtain the induced currents in the screen due to a current flowing through the conductor.
Thanks in advance.
Attachments:
Hello Andrew Kitimbo
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Same question. I want to check surface current density in coil domain using a single turn coil feature.
Unable to find the right relation between the global calculation of Comsol and the integration of currents.
Anyone?
Best regards.
Julien