Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Tubular permanent magnet motor modeling

Posted 2015年11月21日 GMT-5 13:59 Low-Frequency Electromagnetics, Structural Mechanics 0 Replies

Daniel F. Daza
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I just took a look at a new model in the application gallery, called "Tubular Permanent Magnet Generator":

www.comsol.com/model/tubular-permanent-magnet-generator-20381

In the case of the generator, I think the modeling process is rather straightforward, because at the end the objective is to obtain the induced voltage induced by the permanent magnets and their movement. However, how should we modify this model as a motor, so that after a three-phase current is applied to the primary, we can compute the force exerted in the magnets?
0 Replies Last Post 2015年11月21日 GMT-5 13:59
COMSOL Moderator

Hello Daniel F. Daza

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content