Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling Joule Heating of Electrosurgical Plasma Discharge
Posted 2017年3月2日 GMT-5 14:54 Plasma Physics, Heat Transfer & Phase Change, Geometry, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hello, I am trying to plot a 2D model of the joule heating characteristics of a tri-polar electrosurgery knife. I am experiencing multiple errors while trying to compute studies. The two physics components for joule heating are heat transfer in solids and electric currents. There are two outer electrodes set to ground, a center electrode with a voltage of 480V, two strips of Teflon to act as an insulator for a portion between the outer and center electrodes, and the whole geometry is in a Saline solution environment.
When I try to run the simulation, I encounter the following error reports:
Failed to find a solution.
Maximum number of Newton iterations reached.
There was an error message from the linear solver.
The relative residual (0.14) is greater than the relative tolerance.
Returned solution is not converged.
Attached is the model I am working on.
Any advice is appreciated,
Thank you
When I try to run the simulation, I encounter the following error reports:
Failed to find a solution.
Maximum number of Newton iterations reached.
There was an error message from the linear solver.
The relative residual (0.14) is greater than the relative tolerance.
Returned solution is not converged.
Attached is the model I am working on.
Any advice is appreciated,
Thank you
Attachments:
1 Reply Last Post 2017年3月3日 GMT-5 03:33
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hi,
Try to do a time dependent study.
Good luck
Try to do a time dependent study.
Good luck
Attachments: