Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error 4100
Posted 2011年3月21日 GMT-4 21:20 Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
HI there,
I perform a simulation on a motor using the AC/DC module-perpendicular induction currents,vector potential (emqa). My subdomains include, rotor, stator, air, shaft and winding area. When i am meshing it using finer mesh size, i get this error message displayed:
"Error 4100. Failed to generate mesh for subdomain 2. Subdomain 2: Internal error in advancing front mesher"
What does this mean? SHould i just use the normal mesh? will the result of flux be different between normal mesh and finer mesh size?
Thank you in advance for your time and help.
I perform a simulation on a motor using the AC/DC module-perpendicular induction currents,vector potential (emqa). My subdomains include, rotor, stator, air, shaft and winding area. When i am meshing it using finer mesh size, i get this error message displayed:
"Error 4100. Failed to generate mesh for subdomain 2. Subdomain 2: Internal error in advancing front mesher"
What does this mean? SHould i just use the normal mesh? will the result of flux be different between normal mesh and finer mesh size?
Thank you in advance for your time and help.
1 Reply Last Post 2011年3月22日 GMT-4 02:25
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
there are certainly cereal possibilities to generate this error. What I have noticed is that when you have a geometry that loop around torus or with a central cut, you often get such an error. What I do is to cut my geometry into a few parts and then mesh one by one, if the global meshing is not successful
--
Good luck
Ivar
there are certainly cereal possibilities to generate this error. What I have noticed is that when you have a geometry that loop around torus or with a central cut, you often get such an error. What I do is to cut my geometry into a few parts and then mesh one by one, if the global meshing is not successful
--
Good luck
Ivar