Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Vanishing Boundary Conditions With Changing Geometry

Posted 2018年3月4日 GMT-5 17:41 Structural & Acoustics, Structural Mechanics Version 4.3b 0 Replies

Ganesh Patil
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I want to study effect of geometry on results. I am changing thickness of my components. I have set thickness as my parameter in parametric sweeping.

But whenever I run my simulation, all my boundaries which I had already defined in boundary conditions vanishes. I believe this might be because of changing face number at boundary as geomert thickenes. Is there any solution to this problem? I tried with selections, but same issue occurs

0 Replies Last Post 2018年3月4日 GMT-5 17:41
COMSOL Moderator

Hello Ganesh Patil

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content