Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Freezing through convergence Plots
Posted 2018年5月23日 GMT-4 08:35 General, Results & Visualization, Studies & Solvers Version 5.2a 0 Replies
Please login with a confirmed email address before reporting spam
According to
http://cn.comsol.com/forum/thread/105901/comsol-5-2-gets-stuck-after-some-time?last=2017-04-26T18:39:50Z
Comsol freezes occasionally when plots are created while solving, including the convergence plots. For my model (SST Flow, around 1,500,000 elements, 128 GB RAM), it happend three times in a row. After disabling the plots, it works pretty good.
Is there a possibility to see the convergence plots after the simulation is finished? Or see at least the Errors? They are not even shown in the progress when the convergence plots are disabled.
It´s pretty important for me, because I use two different rampings (viscosity and and a wire gauze), and i often only find a soluation when i use the interation number as a criteria.
Please don´t suggest to upgrade the version to 5.3, I use Comsol for my Master Thesis, and the Prof is not willing to pay for the new version...
Hello Henrik Bode
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.