Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Thin film meshing

Posted 2011年7月18日 GMT-4 23:33 Version 4.0a 2 Replies

JiYoung Park
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am doing joule thin film heating work

There are two electrodes ( 1[cm]*0.1[cm]*0.1[cm] ) contacted on the substrate( 1[cm]*1[cm]*30[nm] ) at sides

I've meshed by two method but there were problem.

1. free tetrahedral z scaling

- problem : Nonsymmetric matrix found

2. 2D meshing and swept

- problem : no matching meshing at connected area

plz help...

Any comments will be appreciated .

Thanks !
2 Replies Last Post 2011年7月19日 GMT-4 22:02
Dennis Brown
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年7月19日 GMT-4 14:18
Check out this knowledge base support item. There are a couple examples (in different versions of comsol) on doing thin meshes.

www.comsol.com/support/knowledgebase/120/
Check out this knowledge base support item. There are a couple examples (in different versions of comsol) on doing thin meshes. http://www.comsol.com/support/knowledgebase/120/
JiYoung Park
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年7月19日 GMT-4 22:02
great thanks!
great thanks!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content