Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

boundary condition problem for Free and porous media flow

Posted 2011年10月20日 GMT-4 12:52 Fluid & Heat Version 4.1 1 Reply

Pavel Polyakov
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am trying to simulate fluid flow (Free and porous media flow) in the rectangular geometry. At the boundary i need to specify the gradient of velocity (not the velocity by itself, that can be easily done by choosing the option 'wall' (slip no slip, moving wall ect ...)). I did not find the possibility to put the gradient of velocity instead of velocity as the boundary condition. Thanks.
1 Reply Last Post 2011年10月20日 GMT-4 14:53
Nagi Elabbasi Facebook Reality Labs
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年10月20日 GMT-4 14:53
It is not common to have a boundary condition specifying just the gradient of the velocity in free flow. Even then you cannot use the whole velocity gradient tensor but only the normal projection of that gradient. Can you use the Boundary Stress condition instead? It is the closest “Neumann” boundary condition that involves velocity gradients.

Nagi Elabbasi
Veryst Engineering
It is not common to have a boundary condition specifying just the gradient of the velocity in free flow. Even then you cannot use the whole velocity gradient tensor but only the normal projection of that gradient. Can you use the Boundary Stress condition instead? It is the closest “Neumann” boundary condition that involves velocity gradients. Nagi Elabbasi Veryst Engineering

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content