Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Port boundary condition

Posted 2019年12月23日 GMT-5 09:34 Acoustics & Vibrations Version 5.5 0 Replies

Atabak Pourreza
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am modeling a straight duct with rectangular cross section. I have one inlet and one outlet. and I am using acoustic pressure to model the acoustic field inside the duct. I am applying port boundary condition at both ends of the duct and putting plane wave excitation at the inlet with a known amplituide (as the dominant mode) but I would like to have also the first higher order mode excitation (the frequency is above the first cut on frequency). My question is if I define another port at the inlet, what should I put as the amplituide for the higher order mode? or how can I have both the plane wave and higher order mode excitation as incident wave at the duct inlet?

Thanks all,

0 Replies Last Post 2019年12月23日 GMT-5 09:34
COMSOL Moderator

Hello Atabak Pourreza

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content