Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Prescribed Displacement in radial direction for 2D Axisymmetric Analysis

Please login with a confirmed email address before reporting spam

Hello

I've been trying to run a simulation for an elastic body which has axial symmetry. However, I could not provide a displacement in radial direction. While imposing a displacement, the body just deforms but could not pass the axial symmetry line. Also, I could not implement an antisymmetry condition to the body.

Is it possible to impose a displacement to a body in 2D Axisymmetric analysis as depicted in the figure below.



1 Reply Last Post 2020年6月23日 GMT-4 03:39
Edgar J. Kaiser Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年6月23日 GMT-4 03:39

This obviously breaks the axial symmetry, no?

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
This obviously breaks the axial symmetry, no?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.