Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Re-starting a simulation with a different geometry

Posted 2021年4月10日 GMT-4 08:40 Chemical, Computational Fluid Dynamics (CFD), Geometry 0 Replies

Natan Padoin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

I have a case where a deforming geometry is running time-dependent. At a certain time I need to stop the solution, copy the solution at that point. Then, I need to re-start the model with a slight modification of the original geometry, but taking the copied solution from the previous cases as a starting point. Is it doable in COMSOL?

Best regards, NP

0 Replies Last Post 2021年4月10日 GMT-4 08:40
COMSOL Moderator

Hello Natan Padoin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content